Quick Tutorial - PMP/HCMPΒΆ

This section is a quick tutorial for experienced Windows or Mac users. It describes how to create a project to connect two Subscriber Modules to an Access Point on a Hub Site.

Before starting this tutorial, complete the following steps:

  1. Install the software in the usual way. See Installing LINKPlanner.
  2. Start the application.
  3. Enter the correct details in the Options (Preferences) page. Ensure that Email address and Network Settings are correct. See Options (Preferences).
  4. Register with the path profile service. See Options (Preferences).

There are three parts to this tutorial:

  1. Create a project with one hub site, one Access Point and two Subscriber Modules. See Creating Project, Access Points and Subscriber Modules (PMP).
  2. Update the path profile for the link with obstructions. See Updating Profile with Obstructions (PMP).
  3. Adjust the antennas at both ends of the link and confirm that the selected equipment meets the performance requirements. See Reviewing Performance and Adjusting Configuration (PMP).