Advanced Features

To improve the performance of links additional features are available in certain PTP products.

For PTP 650, 670 or 700

• Optimize E1 or T1 latency, see Optimizing E1 or T1 Latency

For PTP 650, 670 or 700

• Use TDD Synchronization, see Setting TDD Synchronization. For further background information giving an overview of Time Division Duplex, see TDD Overview or for an overview of TDD Synchronization, see TDD Synchronization Overview.

For PTP 800, 810 or 820

• Enable Hot Standby Protection, including Spatial Diversity, see Setting Hot Standby Protection (1+1)
• Use 2+0 Antenna Sharing, see Setting 2+0 Antenna Sharing

For PTP 800, 810 or 820

• Installing IRFUs (PTP 800i/810i) or RFU-As (PTP 820i) indoor, see Long Waveguide

For PTP 800

• Installing ODUs indoor or at the base of the tower, see Long Waveguide

For PTP 650, 670, 700, 800, 810, 820C and 820G products

• Use Diversity, including Reflections, see Setting Diversity

• Optimizing E1 or T1 Latency
• Setting TDD Synchronization
• TDD Overview
  • TDM Mode
  • IP Mode
  • Symmetry
  • Summary
• TDD Synchronization Overview
  • Unsynchronized Links
  • Synchronized Links
• Setting Hot Standby Protection (1+1)
  • Hot Standby Configuration at Each End
  • Hot Standby Bill of Materials
  • Hot Standby Performance Summary
  • Hot Standby Reports
    • Detailed Proposal Report
    • Detailed Installation Report
• Setting 2+0 Antenna Sharing
  • 2+0 Equipment Configuration
  • 2+0 Configuration at Each End
  • 2+0 Bill of Materials
  • 2+0 Performance Summary
  • 2+0 Reports
• Long Waveguide
  • Long Waveguide Configuration at Each End
  • Long Waveguide Bill of Materials
• Setting Diversity
  • Space Diversity
    • Reflections over Water
    • Multipath Reflections
  • Configuring Spatial Diversity in LINKPlanner
    • Unlicensed
    • Licensed
  • Height Clearance
  • Frequency Diversity
  • Improvement Factor Equations